Lucky Hands® water with low lime content

Problem: Clumping during preparation of impression material with hard water

From our many years of experience, we know that tap water is often used when preparing impression material. There is a risk that clumping may occur due to the lime content and the associated hardness. This often leads to disappointment and incomprehension among our customers.

90% Solution: Use of distilled water

We therefore strongly recommend using distilled water. But even then, in a few rare cases, clumpy results can occur.

100% Solution: Years of tried and tested impression water from 3D Hand Design for a guaranteed lump-free application

At the same time, we have never had any problems with the water we have used for more than a decade. This is pure, high-quality Barmer Talsperrenwasser from the Bergisches Land region.

What could be more natural than to offer our customers the necessary water in addition to our existing impression kits, so that you can have a successful experience with a guaranteed lump-free result when preparing impression powder?

In line with our impression kits, you can get our long-proven impression water in containers of 1, 3 and 5 liters.

Our promise - your security

Only with us do you get impression water for the guaranteed absolutely lump-free preparation of your impression material. Take us at our word! If, despite using our special impression water, you do not achieve a lump-free result with our impression kits, you will get your money back. Should the impression material actually clump, it is sufficient to send us a photo of the lumpy impression material and a remnant of the existing impression powder as proof.

The guarantee only applies if purchased simultaneously with at least one of our impression kits!